Home  > Haida Products  > Baby Stroller / Bicycle / Toys Testing Machine  >  ASTM F2236 Baby Carrier Tester
Haida Equiment Manufacturer

Haida Equiment Manufacturer has more than 15 years experience for test equipment...

ASTM F2236 Baby Carrier Tester

ASTM F2236 Baby Carrier Tester

15 days after order.
Each set protected with resin fiber and PP film, then put into Strong wooden case with operation manual and video inside.
L/C, D/P, T/T

ASTM F2236 Baby Carrier Tester

1) a backing band to withstand shock up and down, to assess the firmness of the tie-down straps.
2) Power supply: 220 volts, 1000 watts
3) Design standards: ASTM F2336

Equipment Summary:

The stroller detection in accordance with state laws and regulations and relevant standards, to determine the primary means of stroller products as well as raw material quality, performance, qualified or not. Baby car detection system in terms of bicycle products quality and safety evaluation, market supervision and product trade plays an important technical support, to ensure product quality and safety, bicycle, plays an important role in raising the overall level of bicycle industry. Detection mechanism for baby carriage through the use of scientific methods of detection and precision instrument and equipment, to detect on the product, the quality inspection results are accurate, and feedback to the enterprise. In this way, the enterprise according to the detection results of separation of nonconforming product, and analyze the quality problems, propose corrective measures. Through the process of inspection, feedback, correction, promote the enterprises to improve product quality.

Correspond Standard:

EN 13209-2, ASTM F2336.

Baby car as far as possible not to use in any of the following circumstances:

1.Vibration, rocking occasions.

2.Direct sunlight.

3.Hot, dusty, humid places.

4.The AC power supply should be well grounded, to ensure safe use.

5.It is prohibited to use strong solvents, such as benzene, nitro categories oil for cleaning machine.

6.Shall not be injected into the water and debris inside the machine, in order to prevent damage to electrical

components and electrical shock.

7. The disassembling and assembling and debugging of the instrument display can only be approved by the

national metrology units and the company, other people are not allowed to overhaul.

Leave a Message


Loading verification code...

Please complete verification first

Chat Online
Chat Online
Leave Your Message inputting...