Home  > Haida Products  > Environmental Test Chamber  > Climatic Test Chambers  >  Temperature Cycle Test Chamber
Haida Equiment Manufacturer

Haida Equiment Manufacturer has more than 15 years experience for test equipment...

Temperature Cycle Test Chamber

Temperature Cycle Test Chamber

15 days after order.
Each set protected with resin fiber and PP film, then put into Strong wooden case with operation manual and video inside.
L/C, D/P, T/T

Programmable Temperature Cycle Test Chamber

Temperature cycle test chamber can do high temperature and extremely low temperature environment in the shortest time to temperature cycle test by the programmable controller.the temperature test chamber have 3 zone temperature chamber:high temperature chamber,low temperature chamber,test chamber.



Temperature cycle test chamber is widely used in metal, plastic, rubber, electronics and other materials and it can be used as an important reference for improving product quality. It meets the standard of MTL, IEC, JIS, GJB…


Main parameters:

Test method

Pneumatic operated door switch 3 chambers

Inner dimension (W*D*H)


External dimension (W*D*H)


Temperature range

-40 ~ +80

High temperature chamber pre-heating range

60 ~ 100

Heating speed

+60→+100 about 10 minutes

Low temperature chamber pre-cooling range

-65 ~ 0

Cooling speed

Ambient →-65 about 65 minutes

Temperature deviation


Thermal recovery time

Within 5 minutes

External material

Antirust processing cold-rolled steel sheet

Internal material

SUS#304 stainless steel

Thermal insulation material

Polyurethane foam and fiberglass


R404A / R23

Cooling method

Air cooling


0.2 - 0.5Mpa

Power supply

Three phase, 380V, 50Hz

High low temperature:

HAIDA temperature cycle test chamber is equipped with the late heater and cooler.The heater can Provide the temperature of the high temperature chamber at 0up to 100 in about 10 minutes.and the cooler can reduce the temperature of low temperature chamber to -60 by air cooling ways.


High and low temperature cycle test:

Chamber with vertical 3 zone test structure, pneumatic damper switch 3 box-type test mode, high and low temperature impact temperature recovery time in 5 minutes.programmable temperature controller, with high memory capacity, can save 100 programs, max 9999 cycles, each cycle max time 999hrs.


Programmable controller:

Operate interface: 6" color LCD touch screen

Program memory capacity: 100 groups (modify by operator)

Setting range: Time: 1 minute ~ 99 hour 59 minute, cycles: 1~ 999 cycles

Resolution: temperature: 0.01 ℃; time: 1 minute

Input: T thermocouple

Control method: P.I.D control

Safety devices

Leakage and breaker, over temperature, low temperature protect device, exhaust valves, sample power control terminal, over temperature protection of high and low chamber, compressor over pressure, over heat protection, out of water relay, heat relay of fan, compressed air pressure switch, fuse, external alarm terminal


Additional functions:

Timer, over temperature and power failure protection, alarm, record test curve, emergency stop, display test time

Circulated cooling water: pressure: 0.20.4MPa, temperature: ≤30

Standard configuration: indication lamp of test chamber, time meter, test hole for wire routing, 6pcs castor, 4pcs adjust wheel.

Drive device:

Pneumatic cylinder: Drive the air door of high, environmental, low temperature

Air compressor: Provide the compressed air for driving pneumatic door (supplied by buyer)


Refrigerating device:

Cooling method: mechanical compression refrigeration

Refrigeration compressor:  Semi-closed piston

Refrigerant: R23/R404A

Condensation: Stainless steel welded plate heat exchanger


Leave a Message


Loading verification code...

Please complete verification first

Chat Online
Chat Online
Leave Your Message inputting...